Frequently Asked Questions (FAQ's) Aeroflash Signal

Frequently Asked Questions (FAQ's)	Home : Frequently Asked Questions (FAQ's)

TECHNICAL QUESTIONS AND ANSWERS

Q.	What gauge wire should I use to run out to the power supply from the switch?
A.	You should use 18 gauge wire.
Q.	What kind of wire should I use if the power supply is going to be placed in the fuselage?
A.	You should use 18 gauge shielded cable.
Q.	What size breaker should I use for a (12v Single Flash) 152-0007?
A.	If the power supply is wired separately you should use a 2 amp breaker. If the power supply is wired together (with the other wing) you should use a 5 amp breaker.
Q.	What size breaker should I use for a (24v Single Flash) 152-0010?
A.	If the power supply is wired separately you should use a 1.5 amp breaker. If the power supply is wired together 9with the other wing) you should use a 3 amp breaker.
Q.	What size breaker should I use for a (12v Double Flash) 152-0011?
A.	If the power supply is wired separately you should use a 2.7 amp breaker. If the power supply is wired together (with the other wing) you should use a 6 amp breaker.
Q.	Can you use a different lamp manufacturer with an Aeroflash power supply or vice versa?
A.	We do not recommend this procedure as it may damage the lamp or power supply.
Q.	Power supply charges but no light output, how do I check unit?
A.	With a volt meter, take the ground lead (from the meter) to the ground (of the unit) and using the red lead (from meter) at pin #1 (on the 3 pin nylon connector) you should have a reading of 350v to 450v output, at pin #2 you should have a reading of 0v output and at pin #3 you should have a reading of 150v to 175v output.
Q.	Do I need a dummy load resistor to a beacon flasher?
A.	This load resistor is needed for the single light load and also for the longevity of lamp and flasher.

For more information or other questions, use our Contact Us page, or call 312-733-3513 Ext. 300 (6:00 AM to 2:30 PM Central Time).